RIP Protocols Defined in This Excellent Example Run in GNS3 on Linux
an excellent GNS3 example for understanding the RIP protocols and static router tables in the configuration of CISCO routers. This document contains all the configuration files for a…
https://www.electronics-engineering.com/en/rip-protocols-defined-in-this-excellent-example-run-in-gns3-on-linux/
an excellent GNS3 example for understanding the RIP protocols and static router tables in the configuration of CISCO routers
this document contains all the configuration files for a GNS3 example in which, from a Linux terminal, you can open a telnet terminal to a router located behind two other routers using the RIP protocol. The example also shows how it is possible to communicate with the outside using the cloud

sudo su -
modprobe tun
tunctl
ifconfig tap0 192.168.1.100 netmask 255.255.255.0 up
iptables -I INPUT 1 -i tap0 -j ACCEPT
sudo route add -net 21.21.21.0 netmask 255.255.255.0 gw 192.168.1.101NET FILE OF THE PROJECT AND ROUTER CONFIGURATION
This archive contains the NET file that has to be opened in GNS3.
There are also the configuration files of the three routers.





Sono l'autore di questa pagina su «Protocolli RIP Definiti in Questo Ottimo Esempio Eseguito in GNS3 in Ambiente Linux». Se qualcosa non è chiaro, se vi serve un esempio in più o volete approfondire un punto, scrivetelo qui sotto nei commenti: rispondo personalmente. Se la pagina vi è stata utile, lasciate un voto con le stelle in cima all'articolo.
il documento di riferimento per questo articolo e’ presente in
http://www.ielettronica.it/argomenti.php?idTesiProgApp=4248
inserire la riga in linux:
sudo route add -net 21.21.21.0 netmask 255.255.255.0 gw 192.168.1.101
non dovrebbe essere importante se il route di default e’ configurato correttamente.
il route di default in linux prevede il collegamento con il primo router collegato.
anziche’ la riga:
sudo route add -net 21.21.21.0 netmask 255.255.255.0 gw 192.168.1.101
si puo’ anche usare il default gateway. Spesso il default gateway e’ usato per il collegamento a internet per eth0. In questo caso quindi se si usa il default gateway spesso si perde il collegamento a internet. Ci sono comunque delle tecniche per mettere due default gateway in linux senza avere conflitti
il documento di riferimento di questo documento e’ presente in:
http://www.ielettronica.it/articolo_4248-configurazione_dei_router_cisco.htm