Skip to content
ELECTRONICS ENGINEERINGelectronics-engineering.com
Computer Architecture Progetti con microcontrollori

A Working Example with Interrupts and Serial Communication on Arduino

This example highlights Arduino's great capabilities in handling interrupts. In this example an output variable follows an input variable with a delay of a very few microseconds…

https://www.electronics-engineering.com/en/a-working-example-with-interrupts-and-serial-communication-on-arduino/

Was this page useful? Rate it:
average 5.0 from 1 rating
A Working Example with Interrupts and Serial Communication on Arduino

This example highlights Arduino’s great capabilities in handling interrupts.

In this example an output variable follows an input variable with a delay of a very few microseconds

A WORKING EXAMPLE WITH INTERRUPTS AND SERIAL COMMUNICATION  

With this program, the Arduino generates a 20 µs pulse from the loop function. This pulse enters another input of the Arduino. Through an interrupt from this second input a serial command is generated and a new output is derived.  From the serial port a 1 is obtained for every pulse and the new output is a square wave whose edges are the instants of the pulses.

// A simple sketch to read GPS data and parse the $GPRMC string 
// see http://www.ladyada.net/make/gpsshield for more info

#include <NewSoftSerial.h>
NewSoftSerial mySerial =  NewSoftSerial(2, 3);
#define GPSRATE 4800
//#define GPSRATE 38400
int pbIn = 0;                  // Interrupt 0 is on DIGITAL PIN 2!
int ledOut = 13;                // The output LED pin
volatile int state = LOW;      // The input state toggle
int ledPin = 8;

void setup()  { 

   pinMode(ledPin, OUTPUT);      // sets the digital pin as output
   // Set up the digital pin 2 to an Interrupt and Pin 4 to an Output
  pinMode(ledOut, OUTPUT);

  //Attach the interrupt to the input pin and monitor for ANY Change
  attachInterrupt(pbIn, stateChange, RISING);
  Serial.begin(GPSRATE);
  mySerial.begin(GPSRATE);
} 
 
 
void loop()  { 
  
  digitalWrite(ledPin, HIGH);   // sets the LED on
  delayMicroseconds(17);        // waits for 17ms
  digitalWrite(ledPin, LOW);    // sets the LED off
  delay(1000);                  // wait for 1s with tune
}

void stateChange() {
  Serial.print("1");
  state = !state;
  digitalWrite(ledOut, state);
}

Applications

With this code the Arduino can be used as a pulse generator through a coaxial cable and at the same time forward a flag message to a PC over the serial (USB) port. This flag can be read by software created on the PC (for example with C++) that sends a suitable signal synchronised with the pulses to a different serial port.

This is the typical example of a simulator of a GPS receiver that supplies position coordinates and time over the serial port associated with the instant of the 1PPS pulse.

5 TO 10 V HIGH-FREQUENCY SQUARE-WAVE AMPLIFIER

Often the pulse signal of the GPS receiver is 10 V: 10V 1pps, whereas the Arduino output is 5V, so a small 5V to 10V amplifier also has to be developed, described in this post

Subscribe
Notify of
guest
1 Comment
Oldest
Newest Most Voted
1
0
Would love your thoughts, please comment.x
()
x