Skip to content
ELECTRONICS ENGINEERINGelectronics-engineering.com
Digital Signal Processing

Notes on Digital Control Systems

The first uses of computers in the field of automatic control date back to the late 1950s. At that time the available machines were extremely expensive, bulky, delicate and of modest reliability. All this…

https://www.electronics-engineering.com/en/notes-on-digital-control-systems/

Was this page useful? Rate it:
average 4.0 from 1 rating

The first uses of computers in the field of automatic control date back to the late 1950s. At that time the available machines were extremely expensive, bulky, delicate and of modest reliability. All this limited their use to a few large plants where they performed supervisory and non-vital tasks: data acquisition, statistics on plant operation, setting the reference values for the regulators, of course all analogue, according to preset time sequences. All these functions were concentrated in a single computer not only because it was unthinkable to use several for reasons of cost, but also to allow for an analogue system or a second computer to be activated should the main one fail (a far from rare event). Other reasons hindered their use, particularly in closing control loops. Among these is the distance between the computer and the sensors and actuators, which required lines for the transmission of (analogue) signals, further damaging reliability.


The situation began to change drastically in the early 1970s, with improvements in the design and manufacturing technologies of very-large-scale integrated circuits (VLSI). They made it possible to build solid-state memory circuits and microprocessors, as well as circuits performing interface functions. These components allowed the construction of small computers (microcomputers) of very limited size, able to withstand even very severe environmental conditions and above all at very low cost. The continuous, regular and therefore predictable improvement of all the characteristics of these components then raised strong expectations in scholars and designers of control systems, who therefore planned to use new components even before they were marketed or even designed, thereby in turn stimulating their development.

Subscribe
Notify of
guest
1 Comment
Oldest
Newest Most Voted
1
0
Would love your thoughts, please comment.x
()
x